Seleccionar página

In the family of reducers, planetary reducers are trusted in servo, stepping, DC and other transmission systems due to their small size, high transmission efficiency, wide deceleration array and high precision. Its role is to reduce the speed boost torque and reduce the load/motor second of inertia ratio under the premise of making sure precision transmission. During the past few years, some users possess suffered from unnecessary damage when the reducer is normally broken because of human factors such as illegal installation. Therefore, to be able to better help the users to use the reducer, I’ll introduce you in detail how to properly install the planetary reducer.
Proper installation, use and maintenance of the reducer is a significant component of ensuring the standard procedure of mechanical equipment. Therefore, when installing the planetary reducer, be sure to thoroughly assemble and utilize it in rigorous accordance with the next Rueda de espigas installation and use.
El primer paso
Before installation, confirm if the motor and reducer are intact, and strictly check whether the dimensions of the parts connected to the reducer are matched. Listed below are the dimensions and matching tolerances of the positioning boss, input shaft and reducer groove of the engine.
Segundo paso
Unscrew the screw on the outer aspect of the flange of the reducer flange, adapt the clamping band of the PCS program so that the side holes are aligned with the dust holes, and place the hexagon socket into the hexagon. From then on, take away the motor shaft key.
tercer paso
Connect the motor to the gearbox naturally. When connecting, it should be ensured that the result shaft of the reducer is concentric with the insight shaft of the engine, and the outer flanges of both are parallel. As the heart is inconsistent, it will cause the electric motor shaft to break or the reducer gear to wear.
In addition, it is strictly forbidden going to with a hammer or the like during installation to avoid damage to the bearing or equipment due to excessive axial force or radial force. Make sure to tighten the mounting bolts before tightening the tightening bolts. Before installation, clean the anti-rust essential oil of the motor input shaft, positioning boss and reducer reference to gasoline or zinc-sodium water. Its purpose is normally to ensure the tightness of the connection and the flexibility of operation, and to prevent unnecessary wear.
Before connecting the motor to the reducer, the motor shaft keyway ought to be perpendicular to the tightening bolt. To make sure uniform force, first screw the mounting bolts at any diagonal position, but do not tighten them. After that screw on the mounting bolts at the various other two diagonal positions and finally tighten the four mounting bolts one by one. Finally, tighten the tightening bolts. All tightening bolts should be fixed and inspected using the torque wrenches according to the indicated set torque data.
The correct installation between the reducer and the mechanical equipment is comparable to the correct installation between your reducer and the get motor. The main element is to make sure that the result shaft of the reducer is certainly concentric with the shaft of the powered part.